Troubleshooting - Renlig FWM6 Handbuch

ENGLISH
• Unscrew the hose from the appliance.
Keep a rag nearby because some water
may flow.
• Clean the filter in the valve with a stiff
brush or with the piece of cloth.
35° 45°
• Turn on the water tap.
The dangers of freezing
If the appliance is installed in a place where
the temperature could drop below 0°C,

Troubleshooting

Warning! Refer to Safety
chapters.
Introduction
The start of the appliance does not occur or it stops during operation.
With some problems, it is also possible that the red indicator of button
First try to find a solution to the problem (refer to the table). If not, contact the Authorised
Service Centre.
Warning! Deactivate the appliance before you do the checks.
• Screw the hose
back to the
appliance turning
it to the left or the
right to suit the
installation. Tight
the locknut
correctly to
prevent water
leaks.
proceed as follows to remove any water
remaining inside the appliance:
• unplug the appliance;
• turn off the water tap;
• unscrew the water inlet hose from the
tap;
• unfasten the drain hose from the rear
support and unhook it from sink or
spigot;
•
• place a bowl on the floor;
• let the drain hose run along the floor,
place the external extremities of the
drain and inlet hoses in the bowl placed
on the floor and let water drain out
completely;
• screw the water inlet hose back on and
reposition the drain hose again;
When you intend to start the appliance up
again, make sure that the room
temperature is above 0°C.
24
flashes.