Setting Of Both Switching Outputs - HYDAC AS 1000 Benutzerhandbuch

8

5.2.3 Setting of both switching outputs

By means of the HMG 3010 or the CMWIN software, you have the option of configuring the
switch points of the sensors.
E
Please select the menu point in the "sensor dialogue" of the main menu "SMART-Sensor".
You can now configure the SMART Sensor.
•
Switch output 1: source, output, switch-on point, switch-back point, switch-on delay,
•
Switch output 2: source, output, switch-on point, switch-back point, switch-on delay,
Setting ranges of the parameters
Measuring range
Saturation level
in %
0 .. 100
* All ranges given in the table can be adjusted by the increments shown.
•
Working temperature: Activation temperature AT (applies to both switch outputs),
Setting ranges of the parameters
AT
-25 ... 100 °C
Edition: 2017-07-17
switch-off delay
switch-off delay
Lower limit of
RP
in %
1.0
Over temperature UET
UET
-25 ... 100 °C
HYDAC ELECTRONIC GMBH
Upper limit of Minimum
SP difference betw.
RP and SP
in %
100.0 1.0
Increment
0.1 °C
Aqua Sensor AS 1000
Increment*
in %
0.2
Part No.: 669705