Disconnecting From The Pc - Lenze EPM-H520 Betriebsanleitung

Show/Hide Bookmarks
Commissioning
6. Load the required project from the HMI Designer to
the keypad. (* "HMI Designer - First steps")
•
•
7. After a project download, the program of the system bus adapter must be updated.
! ! ! !
4.2.3

Disconnecting from the PC

1. Switch off the PC.
2. Switch off the supply voltage for the keypad.
3. Remove the EPZ-H110 download cable from the keypad and the PC.
4. Switch on the supply voltage for the keypad.
The keypad is now ready for operation.
76
Activate the field "Keypad - Update program"
under "Downloader".
Activate the field "Keypad - Update firmware"
under "Downloader".
– when downloading a project into the keypad
for the first time,
– after an update of the planning tool "HMI
Designer".
"PROGRAMMING MODE" is displayed while downloading data.
Note!
Example projects for the keypad can be found in the "HMI Designer" planning
!
tool under File -
The project remains saved after the supply voltage has been disconnected.
!
EDBEPM-H520 DE/EN/FR 4.0
- Samples .
Open ...
H520_021
L