Disconnection From The Pc; Status Messages For The Keypad; Indication Of The Operating Status At The Keypad - Lenze EPM-H410 Betriebsanleitung

Show/Hide Bookmarks
Commissioning
4.2.3

Disconnection from the PC

Disconnection from the PC
1. Switch off the PC.
2. Switch off the supply voltage for the keypad.
3. Disconnect the EPZ-H110 programming adapter from the keypad and the PC.
4. Switch on the supply voltage for the keypad.
4.3

Status messages for the keypad

The status of the keypad can be queried any time. Information can be obtained about
•
the interface (port)
•
the name of the loaded driver
•
the version of the loaded driver (Ver)
•
the mains address of the keypad (Addr)
•
the last error
If you want to ...
A. query the status of the keypad
B. close the status message
4.4

Indication of the operating status at the keypad

Display
LED red
LED green
LED yellow
62
The keypad is now ready for operation.
Press keys ...
On
Bus error -
Power Voltage supply is switched
on
Battery Capacity of the internal
battery used up
EDBEPM-H410 DE/EN/FR 2.0
Example
2x Port Port Port Port
shift
Driver : CAN Lenze M Driver : CAN Lenze M Driver : CAN Lenze M Driver : CAN Lenze M
Ver Ver Ver Ver
Addr VT: NO ADDR Addr VT: NO ADDR Addr VT: NO ADDR Addr VT: NO ADDR
Error Error Error Error
ENTER : Set Clock / Contrast ENTER : Set Clock / Contrast ENTER : Set Clock / Contrast ENTER : Set Clock / Contrast
Clr
Esc
Off
No communication error
No voltage supply
Sufficient capacity of the
internal battery
: MSP : MSP : MSP : MSP
: 1.01 : 1.01 : 1.01 : 1.01
: NO ERROR : NO ERROR : NO ERROR : NO ERROR
Blinking
Communication error at
system bus (CAN)
-
-
L