Cleaning the top lid
• Unplug the appliance and let it cool down before cleaning.
• Do not touch the inner lid while it is hot.
• It is recommended to clean the interior of the lid after each use to
avoid hard stains.
• The lid and the seal (B) should not be dismantled.
• Wipe dry with a non-abrasive soft damp cloth and hot water.
A
B
C
D
• It is recommended to avoid metallic and abrasive cleaning products .
• To clean any dirty residues around the seal it is recommended to use
food-safe sanitizing wipes, damp cloth or non-abrasive sponge with hot
water (and vinegar in case of stubborn stains).
• To clean the steam outlet (D), it is recommended to use small bottle
brush , dipped in a hot water.
• To clean off stains on the heating plate (A) on the metallic ring
of the hot plate (C) and to finalize the cleaning of the lid, it is
recommended to launch a steam clean cycle. Mix 500ml of water to
500 ml of white vinegar, and pour into the cooking bowl. Then close the
lid and activate the Steam function for 20 mins. At the end of the cycle,
open the lid and wipe off.
Cleaning and care of the other parts of the appliance
• Clean the outside of the multicooker –the inside of the lid and the cord
with a damp cloth and wipe dry. Do not use abrasive products.
• Do not use water to clean the interior of the appliance body as it could
damage the heat sensor.
22
TROUBLESHOOTING
Problem
Problem
Any indicator light off
The appliance is not
and no heating.
plugged in.
The indicator light has
Any indicator light off
connection issues or is
and heating
damaged."
The lid has been closed
incorrectly
Steam leakage during
using
The lid is damaged.
The 'keep warm'
function was cancelled
Automatic Keep Warm
by the user during the
fails (machine remains
setup. Please refer to
in the cooking mode or
the section on the 'keep
not heating)
warm' function for more
information.
The air fryer can only
The Air Fry fan is not
operate when the lid is
working
closed.
Some functions have
different cooking
The Air Fryer is not
stages, and the air
working
fryer may not start
immediately. This is
normal.
The following scenarios
are considered normal:
There is a little smoke
During initial use. When
coming from the steam
there is excess oil in or
vent
added to the food. If
there is food residue
inside the pot.
Causes
Causes
Solutions
Solutions
Please ensure that
the power cord is
plugged into the
socket and turned on
Send the appliance to
an authorised service
centre for repair
Please open and close
the lid again.
Send the appliance to
an authorised service
centre for repair
Send the appliance to
an authorised service
centre for repair
Please close the lid.
Send the appliance to
an authorized service
center for repair
Refer to the cooking
program table in the
Instruction for Use
No action needed.
EN
23