VEVOR XDB-436B2 Bedienungsanleitung Seite 8

Step 5: The installed side
support end cover E and support
rod I pass through the center of
the cavity.The two cavities are
separated back to back by L.
Caution:Make sure the parts C
towards out side when you put
two chambers together with
part "I".
Step 6: Install support end cover
E on the other side and tighten
screw H using a screwdriver.
Step 7: Fasten mounting support
F into support J of the support
base. Align the arrow pointing
down on support F with the
screw hole, and install and
tighten screw H.
Step 8: Install the lock G on the
support F, noting that G will be
slightly deformed before it can be
stuck into the shaft pin of F,but
there is no need to worry, this is
normal.