VEVOR XDB-436B2 Bedienungsanleitung Seite 7

Step 3:Install both sides of the panels to form
a chamber.
Caution:
1. When installing, pay attention to the
alignment of the buckle and the slot. You
can tap the buckle with your fist or
hammer to tighten the buckle. A "click"
sound is usually heard, indicating that the
buckle is installed in place. If there is an
obvious gap between panel D and side
panel A or B on the side, the buckle is not
installed in place.
2. When the buckle is not installed in
place, press panel D about 40mm from the
edge with your thumb so that panel D is
dented and deformed. At this time, you
can hear a "click" sound, indicating that
the buckle is installed in place.
3. Check whether there is a significant
gap or warped edge between D and A&B,
and ensure that the panel is installed in
place. Install the other panel D in the same
way. So, we've completed the assembly of
the cavity.
Step 4: Install the side support end cover E
and support rod I, and tighten screw H with a
screwdriver.