IKEA HARMONISK Bedienungsanleitung Seite 10

ENGLISH
What to do if ...
Problem
The appliance does not work There is no mains
The hood's suction level is
not enough
The light does not work
LED 1 blinks
LED 2 blinks
Before contacting the Authorized Service
Centre:
Switch the appliance on again to see if the
problem has disappeared. If not, switch it
off again and repeat the operation after an
hour.
If your appliance still does not work properly
after carrying out the checks listed in the
troubleshooting guide and switching the
appliance on again, contact the Authorized
Service Centre, clearly explaining the
problem and specifying:
Possible cause
electrical power
The appliance is not
connected to the
electrical supply
The suction speed is too
low
The metal filters are
dirty
The air vents are
obstructed
The LED is broken
Grease filters are dirty.
Carbon filter is dirty.
• the type of fault;
• the model;
• the type and serial number of the
appliance (given on the rating plate);
• the Service number (the number after the
word SERVICE on the rating plate inside
the appliance).
Solution
Check for the presence of mains
electrical power.
Turn off the appliance and
restart it to see if the faults
persists.
Check if the appliance is
connected to the electrical
supply.
Turn off the appliance and
restart it to see if the faults
persists.
Check the suction speed and
adjust as necessary.
Check that the filters are clean
If not, clean the filters in the
dishwasher.
Check the air vents for any
obstructions and remove as
necessary.
For replacement, contact the
Authorized Service Centre.
Perform maintenance of grese
filter as described in the
relevant paragraph.
Perform maintenance of carbon
filter as described in the
relevant paragraph.
10