Initial Operation; Please Observe The Following Before Initial Operation; Switching On And Off; Safety Features - clage WHT Gebrauchs- Und Montageanleitung

3. Installation
5. Put the electric terminal cover back on.
6. Attach the electric terminal cover with the screw.
7. Insert the device from the top in the 4 lugs on the mounting plate.
8. Push the device down up to the stop.
9. Put one hand on the top of the device to hold it and insert the air intake grille into the
device from the bottom.
10. Fasten the air intake grille and the device with the locking screw.

4. Initial operation

Please observe the following before initial operation

Ensure that the following requirements are met:
• The minimum distances have been maintained.
• The power supply is properly connected.
• All filters are inserted and undamaged.

Switching on and off

The device is switched on and off without contact by means of the sensor:
1. Hold hands or head under the outlet opening of the device.
The sensor automatically switches on the device.
The device is switched off as soon as hands or head are removed from the sensor
range.
The device is automatically switched off if hands or head remain in the sensor range
for a longer period of time: 35 seconds

Safety features

The hand dryer is equipped with the following safety features:
• Safety cut-off sensor after 35 seconds
• Safety temperature limiter in case of overheating, e.g. if the outlet opening is blocked
21
CLAGE
EN