IKEA FIXA Übersetzung Der Originalbetriebsanleitung Seite 9

the exposure level over the total working
period.
Protect yourself against the effects of
vibration by maintaining the tool and its
accessories, keeping your hands warm,
and organising your work patterns.
DECLARATION OF CONFORMITY
We declare under our sole responsibility
that this product, FIXA jigsaw, is in
conformity with the following standards
or standardized documents: EN 60745-1,
EN 60745-2-11, EN 55014-1, EN 55014-2,
EN 61000-3-2, EN 61000-3-3, EN 62233,
in accordance with the provisions of the
directives 2006/42/EC, 2004/108/EC,
2006/95/EC, 2002/96/EC, 2002/95/EC.
Technical documentation at: IKEA of
Sweden AB, Box 702, Tulpanvägen 8,
SE-343 81 Älmhult, SWEDEN.
The undersigned is responsible for
compilation of the technical documentation
and makes this declaration on behalf of
IKEA of Sweden AB.
Christina Niemelä Ström
Business Area Manager
IKEA of Sweden AB
INSTRUCTIONS FOR USE
Before any work on the machine
•
itself, pull the mains plug.
When mounting the saw blade, wear
•
protec tive gloves. Danger of injury
when touching the saw blade.
Selecting a Saw Blade
Use only T-shank saw blades. The saw
blade should not be longer than required
for the intended cut. Be sure to choose a
saw blade that is intended for the type of
material you are going to cut.
Inserting the Saw Blade (see figure A)
Clean the shank of the saw blade before
in serting it. An unclean shank cannot be
fas tened securely.
Slacken the two socket head screws (13)
using the included Allen key (11). Insert
the saw blade in the saw blade holder as
far as possible. The teeth of the saw blade
must point upward and forward. Tighten
the two socket head screws (13) using the
Allen key.
While inserting the saw blade, pay
attention that the back of the saw blade is
positioned in the groove of the guide roller
(5).
Precise cuts are only possible when the
guide roller (5) faces closely but not too
tight against the back of the saw blade
(the saw blade (6) may not be bent by the
guide roller). If required, loosen the socket
head screws (14) and move the holder (7)
of the guide roller in such a manner that
the guide roll er faces closely against the
back of the saw blade. Tighten the socket
head screws (14) again.
Check the tight seating of the saw
blade. A loose saw blade can fall out
and lead to inju ries.
Removing the Saw Blade
(see figure A)
Slacken the two socket head screws (13)
using the included Allen key (11). Remove
the saw blade (6) from the saw blade
8