After Use - Bosch BSG 8... Series Gebrauchsanweisung

Vacuuming
You have bought an extremely powerful appliance.
The highest suction setting is therefore only recom-
mended for heavily soiled, short-pile carpets and hard
floors.
9
Figure
Adjusting the floor tool:
a)For vacuuming rugs
and carpets
b)For vacuuming hard floors
Floor nozzle with carpet lifter*
10*
Figure
When you pull the floor tool backwards, the rug is
lifted, allowing you to clean underneath its edge.
Vacuuming with accessories
11
Figure
Remove the combination tool upwards
out of the accessory holder.
a) Crevice nozzle
For vacuuming in crevices and corners.
For difficult-to-reach places, the combination tool
can be extended in two stages by pulling out the
crevice nozzle like a telescope.
Pull out the crevice nozzle in two stages until it audi-
bly clicks into place.
The crevice nozzle can be pushed back together by
releasing the telescopic locks (press in the direction
of the arrow).
b)Upholstery nozzle
For cleaning upholstered furniture, curtains, etc.
c) Hard furnishings brush
For window frames, cabinets, profiles, etc.
Fold up the upholstery nozzle in the direction of the
arrow.
The brush ring is extended by turning in the direc-
tion of the arrow.
The brush ring must be turned back in and the
upholstery nozzle folded back up before the combi-
nation tool is inserted into the accessory holder.
12*
Figure
Secure the drill dust nozzle to the handle and then
place against the wall, so that the nozzle drill hole
opening sits directly over where the hole will be
drilled.
Select the lowest power setting and then switch on
the vacuum cleaner.
!
=>
Figure
=>

After use

Figure
Figure
Figure
You have purchased a floor vacuum cleaner which can
vacuum up any type of dry dirt and uses a dust con-
tainer and a dust bag.
We recommend that you use:
– the dust container, specifically for DIY-related clean-
– the dust bag mainly for everyday household cleaning.
Using the dust container
Figure
Suction holds the drill dust nozzle in the required
position.
Depending on the surface of the wall to be drilled,
it may be necessary to readjust the power to a high-
er setting to ensure the drill dust nozzle is firmly
attached.
Any fine particles are automatically vacuumed up.
Caution: the drill dust nozzle should only be used
in conjunction with the dust container since fine
drill dust can impair the function of the dust bag.
13
You can use the parking aid on the back of the vacu-
um cleaner if you wish to stop vacuuming for a short
time. Slide the plastic lug on the tool connector into
the groove at the back of the appliance.
14
Switch the vacuum cleaner off and unplug the power
cord from the mains.
Tug the power cord and let go. The cable then
rewinds automatically.
The cable break is reactivated by tugging the power
cord again. Tug the power cord again to deactivate it.
15
Press the adjusting sleeve in the direction of the
arrow to release the telescopic tube and slide it in.
16
To store or transport the vacuum cleaner, use the stor-
age aid on the underside of the vacuum cleaner.
Stand the vacuum cleaner up on its end. Slide the
plastic lug on the floor tool into the groove on the
underside of the unit.
ing, e.g. to vacuum up wood shavings, etc.
17
For vacuuming with the dust container, set the
power setting to "bagless".
en
11