Cabling - Medion e1210 Bedienungsanleitung

Cabling

•
Arrange cables so no one can walk on or trip over them.
•
Do not place objects on any of the cables.
•
To avoid damage to your Notebook, connect your peripherals (e.g.,
keyboard, mouse and monitor) whilst your netbook is powered off. Some
devices can be connected whilst your netbook is in use. These devices
usually have a USB connector. Please follow the appropriate instructions for
each device.
•
Keep the netbook at least one meter (approximately three feet) away from
high frequency and magnetic interference sources (e.g., televisions,
loudspeaker cabinets, mobile telephones, etc.) in order to avoid
malfunctions and/or loss of data.
•
Please note that only shielded cables shorter than
3 metres (9.84 ft) should be used for the LPT, COM, USB, IEEE 1394, audio,
video and network interfaces with this netbook. Please use only doubly
screened cables in the case of printer cables.
•
Do not replace the cables supplied. Only use the cable supplied with the
netbook, since that cable will have been tested extensively in our laboratory.
•
Also only use the connection cables supplied with the devices to connect
your peripherals.
•
Make sure that all connecting cables are connected with the respective
peripheral devices, in order to avoid perturbing radiation. Remove any
cables not needed.
•
The connection of devices is limited to equipment that complies with
EN60950 "Safety of information technology equipment" or EN60065
"Audio, video and similar electronic apparatus. Safety requirements".
Safety Instructions
8