Klarstein 10028295 Bedienungsanleitung Seite 6

2. Hang the fan onto the
bracket hook by using
one of the holes at the
top of the upper cano-
py screws.
5. Insert the
two set screws and
washers. Tighten all
the screws, make sure
that the canopy is se-
cure and that you have
not trapped any wires.
3. Connect wires from sup-
ply and the wiring termi-
nals as the photo.
Brown wire: "L"
Blue wire: "N"
Green/Yellow wire:
other 6. Install the fan blades
onto the
tightning the hexafo-
nal screws and spring
washers.
4. Lift
screws reach the bot-
tom of the slots and
then rotate the canopy
counterclockwise until
the screws drop into
the slot redesses.
7. Unscrew the regulator
motor by cover, Connect wires
through the inlet hole
according to the dia-
grams. Mount the re-
gulator on wall on a
wooden base block.
fan until the
6