VEVOR JC35TT-R13R Bedienungsanleitung Seite 11

Reset after the initial installation or power failure
When the display shows an Error code: E07-E09, (Even after
reset, the display still shows error code) it doesn't work when pressing any
button.
Keep pressing the "down" button for 5 seconds, the display
shows RST. Release the button, and press the "down" button again to
reset.
Abnormal Reset
Under the reset status (display flashing RST), Press button
"1" for 5 seconds to switch the memory setting way:
"10.1" means the One-Touch memory program.
"10.2" means the Constant-Touch memory program
At last, press "down" button to finish the reset process, the whole
setting is completed.
Switch cm or inch display unit
Under the reset status (display flashing RST), Press button
"2" for 5 seconds to switch cm or inch height No. display;
"10.3" means the unit of height No. is cm.
"10.4" means the unit of height No. is inch.
At last, press "down" button to finish the reset
process, the whole setting is completed.
- 10 -