Setup - Channels - Output Frequency; Setup - Configuration - Dmx Priority - Mbnled Rgb Dmx Power Supply 2G Bedienungsanleitung

RGB DMX POWER SUPPLY 2G
SETUP – CHANNELS – OUTPUT FREQUENCY
LEDs are controlled by a PWM signal (pulse width modulation). The PWM frequency
can be set in this menu or sychronized via AC mains frequency.
Select MODE and FREQ with the UP-DOWN buttons and press ENTER.
In MODE menu you can choose beween mains synchronisation or free running
(internal snchronisation).
In FREQ menu you can enter your own frequency, if you have selected FREE
RUNNING in MODE menu. Frequency values are adjustable from 85 Hz to 125 Hz.
SETUP – CONFIGURATION – DMX PRIORITY
Here you can enable or disable the DMX priority function. Select your choice with the
UP-DOWN buttons and press ENTER to save the setting.
You can leave this mode at any time without saving changes by pressing the ESC
button.
DMX PRIORITY OFF: When a single program is running or a manual colour is
selected and a DMX signal is present at the same time, the DMX signal will be
ignored and the single program will continue running or the manual colour will still be
displayed.
DMX PRIORITY ON: When a single program is running or a manual colour is
selected and a DMX signal is present at the same time, the single program or the
manual colour selection will be ignored and the DMX signal will now control the
output signal. As soon as the DMX signal isn't present anymore, the device will
automatically return to the single program or the manual colour selection.
rev: 04 22 www.mbnled.com