Switching On - Mbnled Rgb Dmx Power Supply 2G Bedienungsanleitung

RGB DMX POWER SUPPLY 2G
IR – Remote control:
When the IR module is used, stand alone programs can also be selected with the
remote control.
When the device is connected to the mains supply, the dimmer is ready for operation.
During initalzation the MBNLED Logo is displayed for a short time.
After 3 secons the display proceedes automatically. The controller is now in one of
the five main modes.
The display is divided in three parts:
Left the data of the current mode are shown
In the middle is the bar graph for the RGB outputs
Right generic informations of the device are displayed
Generic Informations
Top right of display:
NO LED POWER – No voltage for LED units is measured
OVERHEAT – The device is above the rated maximum temperature
WRONG CONFIG – Internal wiring CA/CC on the power board not correct
FAULT – A not specified error. Please contact the technical service
5V/12V/24V - CA/CC – SYNC/85-125Hz – Correct function
Right middle display:
Current temperature of the device
rev: 04

SWITCHING ON

DISPLAY
16 www.mbnled.com