Main Mode - Single; Main Mode - Master - Mbnled Rgb Dmx Power Supply 2G Bedienungsanleitung

RGB DMX POWER SUPPLY 2G
MAIN MODE – SINGLE
Here various stand alone programs can be selected.
On the display you can see the current program number, maximum number of steps
and the current step number. ‚S' and ‚W' are meaning SPEED time (speed of colour
change) and WAIT time (delay between steps). The SPEED time indicates the
changing speed from one step to the next one. The wait time indicates the delay
time, until the change to the next step is performed. During the wait time the original
channel values remain unchanged.
By pressing the ENTER button several parameters can be selected: program
number, SPEED time and WAIT time. The selected parameter flashes and can be
modified with the UP-DOWN buttons.
You can leave this mode at any time without saving changes by pressing the ESC
button.
If DMX priority is activated (see: SETUP MENU – DMX PRIORITY), the current
program is overwritten by the DMX signal. As soon as the DMX signal stops, the
selected program will automatically be resumed.
MAIN MODE – MASTER
Same functions and operation as in single mode, but an additional DMX signal for the
slave units is generated (master-slave mode). Up to 19 slave devices with different
DMX addresses can be controlled. The number of slave devices with identical DMX
address is virtually unlimited.
rev: 04 19 www.mbnled.com