Werbung
PUMP AND INFLATION
PUMP:
Connect the safety valve to the inflate side of the pump and attach the hose to the safety valve as shown in the diagram
to the left. Never attach the pump to the awning without the included safety pressure valve. The safety pressure valve
ensures that you cannot over inflate the awning.
Failure to use the safety pressure valve when inflating the awning could case you to over inflate the air tube which would
invalidate your warranty.
IMPORTANT:
The ideal inflation pressure for this awning is 7 PSI (0.48 bar).
Do not inflate the awning any more than this. If you use your own pump then ensure it is connected to a safety pressure
valve set to 7PSI or has a pressure gauge on so you can tell what the pressure is at all times.
Over inflation is not covered under your warranty.
Note: Do not over inflate, over inflation is not covered under your warranty and could damage your awning!
INFLATION:
• To inflate your air tube, unscrew the top cap and attach the pump nozzle to the air inlet (as shown below). You are
now ready to pump your air tube up.
If your air tube deflates straight away check that the value is correctly fitted as this could lead to air escaping from
the tube.
DEFLATION:
• To deflate your air tube simply remove the air valve by unscrewing it from the tube.
Be careful when unscrewing the valve as twisting the valve and tube unnecessarily could cause unneeded stress
on the valve. When unscrewing the valve hold the tube in place with one hand and unscrew the valve with the
other thus ensuring the valve and tube are not twisted.
• When you screw the valve back in place be careful not to get it caught on the rim of the valve pocket as this can stop
you creating a seal with the valve and can lead to air being lost from the tube even though there is no puncture.
If your air tube does deflate always first check that the valve is correctly screwed into place.
7
Werbung
