Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation Serra & Corato:
•
Remove the packaging and check if all parts of the fireplace are intact, if not please
contact your dealer.
•
The bioethanol fire has to be mounted stable and steadily, using the supplied wall-
brackets
•
Carefully decide where the fire is to be mounted
•
The wall-bracket is to be fixed horizontally. Use the
supplied level.
•
Attach the wall bracket to the back wall, the
supplied screws and plugs. The supplied plugt
can be used for stone or concrete walls.
•
Hang the fire on the wall-bracket
•
Place the security hook on the bottom of the fire,
use the supplied material.
•
Only mount the fire to a vertical, steady, stable
and fireproof wall
Installation in the surround:
•
Remove the packaging and check if all parts of the fireplace are intact, if not please
contact your dealer.
•
Remove the L-shaped brackets on the sides of the fireplace.
•
Place the insert into the opening of the surround. Attach the L-shaped brackets back
to the sides of the insert, press firmly to the surround before securing the straps.
•
Attach the 2 connectors provided to the corners of the burner with the provided
bolts. The bolts are attached on the bottom side. Then place the glass shield in the
connectors and tighten the hex bolt by hand.
•
Make sure the surround is levelled
Make sure the fire is levelled horizontally and that the back of the fire is placed parallel to the
wall behind it (vertically).
Due to the production of heat around the fire, the backwall can change in colour over time.
Installation of the glass screens:
The glass screens should be mounted on the burner. To do this please use the enclosed
conectors + bolts. This will prevent the airflow pushing against the back wall. It is also used
to control the slide on top of the burner. With two hands you can move the slide forwards
and backwards. If the flames are still striking against the back wall please close the burner
and contact your dealer
Werbung
