RENPHO R-HAP07 Bedienungsanleitung Seite 6

USING THE PRODUCT
1. Before Use
Reminder: Check each part before use and ensure there are no damages.
Push the controller plug into the pad connector and ensure the inner prong is locked in
place. (To remove the controller, lift the locking tab with your finger and pull the controller
plug out directly.)
Plug the cord into an AC 120V (US&CA) / AC 230V (EU&UK&AU) outlet.
Push to
connect
Note:
If there is no power, make sure the electrical outlet is functional and all connections
are secure. Do not turn on the pad until it has been fully assembled.
2. Operation
Note:
1. Always unplug the product from the electrical outlet whennot in use!
2. It's recommended to start at the lowest heat level and gradually increase as desired.
Buttons
Press to set a timer among 2(Default) / 1.5 / 1 / 0.5 hours.
The timer will reset each time it's switched.
Press to switch the heating levels among 1 / 2 / 3 / 4 /
5 / 6.
Press to turn ON/OFF the product.
Pull to
disconnect
Functions
EN-04
A. Controller plug
B. Pad connector