Proper Use - Leifheit Dry & Clean Bedienungsanleitung

3. PROPER USE

• Please note that this product is only intended for household use. Leifheit does not provide a manufacturer's warranty for commercial use.
• Only use this device for cleaning wet, smooth surfaces, such as windows, mirrors and tiles.
• No dust may be sucked in.
• Do not use the window cleaner on rough surfaces so as to avoid damage to the rubber lip.
• The device is not suitable for suction of large quantities of fl uids above 100 ml, fl ammable or sticky fl uids.
• Only use this device in connection with conventional window cleaning agents (no spirits, no foam cleaner). We recommend: Leifheit
Glass Cleaning Liquid or Window Spray.
• Only use this device with the accessories and spare parts approved by Leifheit.
Any other use is considered to be improper. The manufacturer is not liable for damages resulting from improper use. The user alone
shall bear the risk for this.
Figure 2: Window cleaner operating controls
Rubber wiping blade
Suction nozzle
Dirty water tank
(removable)
Side tank valve
for draining
Battery compartment
4. START-UP / CHARGING THE BATTERIES
• The window cleaner is not delivered with a fully charged battery. Therefore, please fully
charge the battery prior to the fi rst use.
• The battery reaches full capacity after some full charges and use cycles.
• Attach the suction nozzle to the tank. Push the two accompanying locking tabs into the tank's
upper surface until you hear the connection make an audible click. The visible screws should
be facing down in this position (see fi gure 3).
• Before you charge the device, please ensure that the device is switched off (see fi gure 4).
• Connect the charger to the charging connector. Plug the charger into the socket. The LED
display will fl ash green while the charging.
The LED will be solid green once the battery is fully charged.
• The battery may only be charged by using the supplied charger.
• The charger is only to be used in connection with the Leifheit window cleaner.
• Always charge the rechargeable battery after work and always store the device fully charged.
5. USE
1. Suction clean the surface
• Clean the window as usual with water and a cleaning agent. Switch the window vacuum on
by pushing the main power switch; the indicator light will be a steady green. Place the rubber
lip of the device on the surface to be vacuumed and use light pressure to pull it from top to
bottom across the surface. To achieve the best results, hold the appliance at a 45° angle to
the pane (see fi gure 5).
• Hard-to-reach surfaces can be suctioned either from top to bottom, sideways or upside down.
If a windowsill or very wide window frames prevent or hinder a vacuuming to the bottom edge
of the window pane, vacuum across the pane once at the end of the vacuuming process.
Tank release button
Operation / battery charge display
Appliance switch (on / off)
Charging connector
Handle receptacle for all Leifheit ClickSystem handles
Base
Figure 3:
Attaching the
suction nozzle
Figure 4:
Appliance
switch in the
off position
45°
Figure 5
45 GB