Maintenance; Replacing Lamps - Gorenje Plus GHV8X Bedienungsanleitung

below the alarm threshold.
You can get out of this mode by pressing key 1 or
2.
Every 30" the sensor checks the environmental
temperature of the display zone.

Maintenance

ATTENTION! Before performing any maintenance
operation, isolate the hood from the electrical
supply by switching off at the connector and
removing the connector fuse.
Or if the appliance has been connected through a
plug and socket, then the plug must be removed
from the socket.
Cleaning
The cooker hood should be cleaned regularly (at
least with the same frequency with which you carry
out maintenance of the fat filters) internally and
externally. Clean using the cloth dampened with
neutral liquid detergent. Do not use abrasive
products. DO NOT USE ALCOHOL!
WARNING: Failure to carry out the basic cleaning
recommendations of
replacement of the filters may cause fire risks.
Therefore, we recommend
instructions.
The manufacturer declines all responsibility for any
damage to the motor or any fire damage linked to
inappropriate maintenance or failure to observe the
above safety recommendations.
Panel
Fig. 22
This model is equipped with a perimetric
suction panel.
The panel allows to optimize the performances
of the hood.
Attention! Hold the panel with both hands when
dismantling and re-mounting in position to
avoid it falling and causing damage to people
or things.
Panel maintenance
Disassembly:
a. pull out firmly (LOWER SIDE) and rotate
upwards.
b. unscrew the safety knob S
c. unhook it from the back hinges.
Cleaning:
The suction panel must be cleaned as frequently
as the grease filter, use a cloth dampened with
neutral washing liquids.
Avoid using products containing abrasives. DO
NOT USE ALCOHOL!
Assembly :
Operate inversely to disassembly.
Attention! always make sure that the panel is well
fixed in its proper place.
the cooker hood
oserving these
Grease filter
Traps cooking grease particles.
This must be cleaned once a month (or when the
filter saturation indication system – if envisaged on
the model in possession – indicates this necessity)
using non aggressive detergents, either by hand or
in the dishwasher, which must be set to a low
temperature and a short cycle.
When washed in a dishwasher, the grease filter
may discolour slightly, but this does not affect its
filtering capacity.
To remove the grease filter, pull the spring release
handle.
Fig. 9-23
Charcoal filter (filter version only)
Fig. 24
It absorbs unpleasant odours caused by
cooking.
The charcoal filter can be washed once every two
months (or when the filter saturation indication
system – if envisaged on the model in possession
– indicates this necessity)
and
suitable detergent, or in a dishwasher at 65°C (if
the dishwasher is used, select the full cycle
function and leave dishes out).
Eliminate excess water without damaging the filter,
then put it in the oven for 10 minutes at 100° C to
dry completely. Replace the mattress every 3
years and when the cloth is damaged.
• Montage
Open the steam screen and remove the
grease filter.
Install the carbon filter on the back of the
grease filter and fix with two rods.
Attention! The rods are included in the carbon
filter packing and not on the hood.
• To dismantle the filter act in the reverse
manner.

Replacing lamps

The hood is equipped with a lighting system based
on LED technology.
The LEDs guarantee an optimum lighting, a
duration up to 10 times as long as the traditional
lamps and allow to save 90% electrical energy.
For replacement, contact the technical service.
11
using hot water and a