Important Safeguards; Operation - KitchPRO Epicuré Gebrauchsanleitung

EN
SOUS VIDE - EPICURÉ

IMPORTANT SAFEGUARDS

When using electrical appliances basic safety precautions
should always be followed including the following:
READ ALL INSTRUCTIONS CAREFULLY
BEFORE USE
• Do not touch hot surfaces and water. Use handles or knobs.
• Use this circulator for only intended use of food prepara-
tion.
• To protect against electrical shock do not immerse cord,
plugs, entire unit in water or other liquid.
• Do not use an extension cord with circulator, Use grounded
power sources only.
• To avoid the possibility of personal injury, always unplug
the circulator from the electrical outlet before handing or
cleaning.
• For indoor use only, Do not use outdoors.
• Close supervision is necessary when any appliance is used
by or near children.
• Do not allowed the children use the appliance.
• Unplug from outlet when not in use and before cleaning.
Allow to cool before putting on or taking off parts.
• Do not operate any appliance with a damaged cord or plug
or after the appliance malfunctions or has been damaged
in any manner. Return appliance to the nearest authorized
service facility for examination, repair, or adjustment.
• The use of accessory attachments not recommended by
the appliance manufacturer may cause injuries.
• Do not let cord hang over edge of table or counter, or
touch hot surfaces.
• Do not place an or near a hot gas or electric burner, or in
a heated oven.
SAVE THESE INSTRUCTIONS.
• DO NOT use an extension cord with this product.
• Operate appliance in water only. Keep the water level be-
tween the "Min" and "Max"levels indicated . Do not use ap-
pliance for other than intended purposes.
• Keep appliance dry. Never operate appliance unless the
water level is between the indicated"Min" and "Max"levels.
Only the heater and circulator portion should be underwater:
Do not immerse the appliance cord, power box, or upper
portion of appliance. If appliance or any of its parts become
submerged, unplug appliance immediately and contact us.
• Unplug appliance. Before moving it, when cleaning, and
generally when not in use. Allow appliance to cool before
lifting or storing.
• Use appliance in a safe indoor environment. Do not use out-
doors. Do not use near explosive or flammable materials. Do
not use with an extension cord. Close supervision is neces-
sary when the appliance is used by or near children. Do not
place on or near a hot gas or electric burner, or in a heated
oven. Note: Appliance is designed for household use only.
2
• Wait for the appliance to cool before moving. Do not
touch hot surfaces.
• Remember circulated water can be very hot. Use a trivet
to protect your countertop from any container being used
with appliance. Use tongs to reach anything inside the
water bath. Extreme caution must be used when moving
containers of hot water.
• Keep safe. If the appliance is dropped in water, damaged,
malfunctions, or the plug or power cord appears damaged
in any way, do not use the appliance Contact us for repair.
The use of unapproved accessory attachments is not rec-
ommended by the appliance and may cause injuries.
• Cover the water bath.Energy can be saved by covering the
water bath with cling wrap cooking. Do not cover any part
of the appliance with cling wrap.

OPERATION

1. Fill the container with water . Fill the water container with
water, using the water level indicator on the NC200, the
water level should be between the MIN
indicated on the front of the circulator. As Archimedes
taught us, the water level will rise when you add food to
the container, so don't fill it up too high. Note: As the
water temperature increases, the water will begin to evap-
orate. the NC200 circulator is equipped with an alarm indi-
cating a low water level, if the water level goes below the
min mark, the circulator will shut off.
Water level between max and min
2. Press the appliance screen. Press the power button
on the screen more than five seconds. The first
line display will then show the setting temperature
of the water, the second line is the current tempera-
ture. The third line shows the set time and work time.
Press the button and
to change the C° and F° .
and MAX
two seconds in same time