Betriebsanleitung / Operating Manual
Motorsteuerungs-Modul AM 830
Motor control modul AM 830
Abbildung 3: Anschlussschema Mehrfachroller
z.B./e.g SHEV 6-RSV / ESM 10/24 RSV
Hauptschalter
(allpolig trennend)
main switch
(disconnect all
poles)
Servicetaster – Not-AUF Taster
service button – security opening button
2.1 Steuerung montieren
GEFAHR
Trennen Sie die Anschlussleitung allpolig vom Netz. Der
Anschluss der Steuerung und Abschaltung darf nur span-
nungsfrei erfolgen!
ACHTUNG
Die Steuerung ist mit Elektronik und Mikroprozessoren
ausgerüstet, die durch falschen Anschluss oder unsach-
gemäße Behandlung zerstört werden können. ESD-Vor-
schriften sind einzuhalten
Die Montage der Steuerung erfolgt gemäß der entspre-
chenden Betriebsanleitung.
2.2 Lastabschaltung AM 830 montieren
Abschaltung AM 830 montieren.
ACHTUNG
Das Kastensystem ist vorher vollständig aufzubauen. Erst
danach ist das Vorhangsystem an die Energieversorgung
anzuschließen.
Abschaltung AM 830 im spannungslosen Zustand mit der
Antriebseinheit des Vorhangs laut Einzeladernfarben
verbinden.
Drehschalter DR1 und DR2, mit geeigneten Werkzeug
auf Position „5" voreinstellen.
Masseanschluss bei Mehrfachrollern verbinden.
Tandemanschluss „T" bei Mehrfachrollern verbinden.
BA_AM-830_M2-3330_DE-EN_15
Seite / Page 6
Anschluss / Connection
Rollerbaugruppe
roller module
AM 830
max. 2 m
Leitungslänge/cable length
www.simon-protec.com
info@simon-protec.com
Figure 3: Connection diagram – multiple roller
Rollerbaugruppe
roller module
Leitungslänge/cable length
2.1 Mounting of the Control Panel
DANGER
Disconnect the connecting cable on all poles from the
mains. The control panel and AM 830 cut-off may be con-
nected only in a de-energised state!
CAUTION
The controller is equipped with circuitry and microproces-
sors that can be destroyed by incorrect connection or im-
proper handling. ESD regulations are to be adhered to.
The control panel is mounted in accordance with the
operating manual.
2.2 Mounting of the Cut-Off AM 830
Mount the AM 830 cut-off.
CAUTION
The box system must be fully assembled beforehand.
Only then may the curtain system be connected to the
power supply.
Connect the AM 830 cut-off in a de-energised state to the
curtain drive unit in accordance with the individual core
colours.
Preset rotary switches DR1 and DR2 to position "5" using
a suitable tool.
Connect the ground connection in the case of multiple
rollers.
Connect the tandem connection "T" in the case of
multiple rollers.
AM 830
max. 2 m
Datum / Date: 16.01.2018
Ausgabe / Issue: 1.5 / 12.2017