Listo RLL145-55b5 Bedienungsanleitung Seite 12

TROUBLESHOOTING
A malfunction may be due to a minor problem that you can solve yourself using the
instructions in the following table. Before calling a technician, perform the following
checks:
Problems Possible
The appliance is not working. Power outage.
The plug is not plugged in or
not properly plugged in.
A fuse has blown or is
defective.
The power point is faulty.
The interior lighting is not The appliance is not plugged
working. in or the LED bulb
Keep strong-smelling food (e.g. cheese) well wrapped.
There are bad odours in the
appliance. Check that there are no expired foods. If there are, remove
them. Check that there are no deposits in the drain (see
above).
Clean the inside of the appliance with water with white
wine vinegar added to it. Then rinse with clear water.
The compressor is running all This is normal
the time. temperature is high.
It is not recommended
appliance or to put food that has not yet cooled in the
appliance.
Pleasedo not open the doors too frequently.
Unusual noises. The appliance is not level.
The appliance is touching the
wall or some other object.
Some noises are typical of
refrigeration appliances.
v.2.o
GUIDE
causes Solutions
Open the door and check
to see if the LED light
comes on.
Plug the plug into the
mains power.
Check the fuse, and
replace it if necessary.
Repairs to the power
supply should be done by
an electrician.
Contact your retailer's
is defective. after-sales service centre.
in the summer when the ambient
to have too much food in the
Adjust the feet.
Move the appliance
slightly.
Go to the section on
"Running noises".
22
Problems Possible
The door seals are not airtight. The door seals are dirty.
Maybe, you have just reversed
the opening direction of the
door.
The appliance does not get The temperature setting is
cold enough. incorrect.
The food is too warm.
The door has been left open
for a long time.
A large amount of hot food
was placed in the appliance
during the last 24 hours.
The appliance is located near a
heat source.
The compressor does not start This is normal, it is not a
immediately after changing
malfunction.
the temperature setting.
There is water at the back The drain hole
of the appliance or on the water is blocked.
shelves.
If the information in this table does not help you resolve your specific problem, do not
attempt to repair the appliance yourself. Contact your retailer's after-sales department.
IMPORTANT:repairs to your appliance should only be performed by
qualified service technicians. Improper repairs can lead to hazards
for users and are not covered by the warranty.
causes Solutions
Clean them with water
and a soft sponge.
Carefully heat the
sections of the seal that
are leaking with a hair
dryer (cool setting). At
the same time, correct
the position of the door
seal with your hand.
Go to the section
on "Setting the
temperature".
Do not open the door for
longer than necessary.
Temporarily set the
thermostat to a cooler
temperature. Avoid
overloading the inside of
the refrigerator.
Go to the "Installation
location" section.
The compressor will start
after a while.
for the defrost Readthe "Cleaning and
maintenance" section.
23 v.2.o