Removal And Installation Of The Battery; Removal Of The Battery - Lindsey-west bicycle BV-F01 Benutzerhandbuch

Recommends
Should not light up all 5 LED supply the battery
with a fully recharge. Connect to the vehicle
battery with the supplied charger. See Chapter
"Charging the drive battery."
Lithium-ion batteries have a
lower self-discharge as
and can therefore stored for about 3
months without recharging.
time the battery is not charged it can still
damage the chemical structure of the
batterycell.
Removal and installation
of battery

Removal of the battery

To remove the battery, proceed as follows (see
illustrations):
• Key switch to the left
• and open the lock (1)
• Open the cap (2)
• Pull out the battery (3)
When reinstalling, you go in reverse sequence.
• Make sure that the contacts of the
(5) get the contacts of the battery
(4). Therefore put the battery with gentle
pressure in the battery bay.
If the cap is not completely closed, the battery
is not seated completely in
controller.
significantly
Nickel batteries
If after this
Battery
controller
the contacts of the
BV-F01 Pedelec
Locking the key switch (1)
on the battery and the optimal electrical contact
to the electronics in the battery
(1)
open
Key
(2)
(3)
taking hold
with Lithium-ion battery
ensures a secure hold
Controller.
31
GB