Location Of Controls - Clatronic BS 1277 Bedienungsanleitung

• Never vacuum without filter. Always check that the filters are fitted
correctly after inserting!
• During use, keep hair, clothing and body parts away from the vacu-
um nozzle!
• Keep the vacuum cleaner away from heat sources, such as radia-
tors, stoves, etc!
CAUTION:
Do not immerse the device into water for cleaning. Please follow the
instructions as stipulated in the chapter "Cleaning and Storage".

Location of Controls

1 Handle
2 On/Off switch
3 Turbo brush
4 Main unit
5 Crevice nozzle
6 Suction hose
6a Hose connector (Fig. H)
7 Height adjustment floor brush
8 Floor brush
9 Guard strip
10 Dust container
10a Dust container button (Fig. N)
11 Pre-filter (Fig. S and T)
11a Rib filter (Fig. O to R)
12 Release dust container
13 Cable rewind
14 Turn cap to release handle
15 Service cover
16 Release button
17 Brush nozzle
18 Upholstery nozzle
19a & b Suction tube
20 Mains cable
21 Motor protection filter (Fig. W)
22 Filter cover (Fig. X)
23 Filter holder (Fig. X)
24 Outlet filter (Fig. X)
Getting Started and User Instructions
Handle
• Lift handle 1 upwards (see Fig. A). It locks in the top posi-
tion.
• Turn cap 14 clockwise to fold down the handle again
(see Fig. B).
34
Connect Suction Hoses (see Fig. D)
• Connect the suction hoses to the floor brush.
• Insert the suction hose ends into the floor brush.
• Turn the left suction hose's end piece anti-clockwise.
• Turn the right suction hose's end piece clockwise.
The suction hoses are now locked in place.
Floor Brush Height Adjustment (See Fig. E)
Select a setting for the flooring with:
high-pile, medium-pile,
Attach Accessories (see Fig. F, G and H)
The accessories are attached to the right side of the vacuum
cleaner. The turbo brush is attached at the handle.
• Disconnect the hose connector 6a from the suction tubes.
• Attachments 3, 5, 17, 18 and 19b can be directly attached
to the hose connector 6a.
• Suction tubes 19a and 19b are nested to save space.
• Pull tube 19a off and turn to extend the tubes.
• Attach parts 3, 5, 17 and 18 again to the open end.
NOTE:
Attachments 3, 5, 17 and 18 cannot be attached to tube 19b.
Electrical Connection
Unwind to the desired cable length and connect to a properly
installed wall outlet.
NOTE:
The top cable rewind holder can be turned 180° to detach
the cable more easily (see Fig. C).
Operating Position (see Fig. I, J)
• Step on the release button 16 to bring the handle into the
operating position.
low-pile.