switching stage and each program (except SOS). the
LED
will
turn into a weak
red.
second
the light will
completely turn off
light off). The battery may remain connected to the light perma-
nently.
Twilight switch: The function „twilight switch" is in the pro-
grams of switching stages No. 8 to 13 (see supplemental
sheet) available. If any of the above programs activated
selection of programs of switching stages in the Expert
the light turns on automatically at the lowest light power swit-
ching stage, starting from a given ambient brightness level.
Please notice: The function is triggered only, when the light is in
standby mode. The Standby mode in the programmes No. 8
to 13 is indicated red flashing, instead of weakly red, to signal
the function „twilight switch".
Gesture control: The function „gesture control" is like the func-
tion „twilight switch" in the programs of switching stages No. 8
to 13 (see supplemental sheet) available. With these function
the light can switched on if it in standby mode and you can
switch from one to the next light power switching stage by a
gesture.
In the first step, the gesture, which is to be used, must be semis-
killed the light. Proceed as follows.
of switching stages
(see selection of programs of switching sta-
ges in the Expert
Mode)
No. 8 to 13
Bring
the
light
in the
position
follow (e.g., with headband on the head).
Status-
Pushing
the
button again > 1
(Status-LED and main
Mode),
Select
one of the
programs
(see supplemental sheet).
in which also the
later use
should
w w w . M y T i n y S u n . c o m
Switch
the light
on
indicates 1 sec
the activated
ge/white, etc.), and is
3 sec
the
button briefly
Now the
Status-LED
the
learning mode
ning mode
will
start. Now the
flashing (main light and Status-LED together), the so called
(see
"Zero
position", where the following switching process begins.
In
this
first phase
position
of the light.
After
the first
twice
mode
will
start. The
(main light and Status-LED together), the so called
position".
Move
process
ends.
Stay
light
will
twice flashing
After
the
second twice flashing
gesture is completed. The
lowest light power switching stage of the choosen program,
the
Status-LED signalize
In order to
switch the light with
perform
this
gesture twice in a
on serves the avoidance of unintentional switch manoeuvres.
Please note the following parameters: maximum time to
perform a gesture: ca. 2,5 Sek.; minimum time to perform a
gesture: ca. 1,2 Sek.; change of the positions during the lear-
ning of a gesture: minimum ca. 10°, recommended ca. 30°.
Tolerance of the movement in the gesture execution: half up to
by
pushing
the
button
shortly. The
program
(eg, red/white, oran-
followed by 3 sec
white.
pressing.
will
display magenta
color, thus
is
activated and
the
first phase
light
store, up to the first twice
of the learning mode
do not change
flashing, the
second phase
light
store, up to the second twice flashing
to the
position
where the following
in this
position without
changing,
a second time.
the
procedure
light turns on automatically
it.
the
learned
gesture, you must
row. The two-times implementati-
Status-LED
Within
these
indicate
of the lear-
the
of the learning
"switching
switching
until
the
of learning a
at the