Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
critical state switches off. The
hing twice
to indicate the activation. Ensure sufficient cooling
for maximum light output and keep your distance to inflammab-
le materials.
• The folkslight system is water resistant according to DIN EN
60529. Cleaning the light with pressurized water, especially
with a high pressure cleaner may cause permanent damage.
• Before using the folkslight system please check if it is subject
to any traffic restrictions in your country.
CHarGInG
Before use, we suggest you fully charge the battery. To charge,
please plug the included charger into an electrical outlet and
connect the battery to the charger. Please ensure the char-
ging takes place in a dry and cool room that is not under fire
danger. During charging, the
red. When the battery
fully
green. You may leave the battery connected to the charger,
even after it has been fully recharged, but only while the char-
ger still plugged into an electrical outlet.
moUntInG
The GoPro® compatible mount provide a variety of attachment
possibilities without any tools. Suitable accessory can be found
at our webshop.
WHY We oFFer DIFFerent moDes anD
proGrams?
The solSlight system is a sophisticated high-end outdoor lighting
rear Status-LED
will be
red flas-
control LED
of the charger will be
charged, the
control LED
will turn
w w w . M y T i n y S u n . c o m
system. It has two operating modes. The "simple" mode
(factory-preset) suffices in most cases for the ambitious outdoor
activists and for this type of user, the control function is delibera-
tely kept simple.
The "expert" mode is designed for outdoor professionals, whe-
re specific requirements can be catered for. The "expert" mode
is equipped with a range of programs which meet the varying
requirements of serious, more professional users. Depending
on the application, programs can be selected which provides
more light, (we have called these "power" programs) or deliver
light over an extended period (and we've called these "eco"
programs).
You can find further details on the supplemental sheet.
operate tHe lIGHt
After mounting the light and the battery pack you are ready to
begin using your light. Please connect the solSlight LED light to
the battery pack.
Note: The light has been delivered factory-preset in the simple
mode. It can be switched on immediately in this mode.
Selection of operating mode "Simple" or "Expert": Each
time you want to
change
between simple and expert
light needs to be
switched off completely
light are off -
see How to switch the light
hold the button
until the light
main light off). This takes approximately 20 seconds. Note:
The Status-LED and the main light will show the SOS mode
once during that switching phase.
mode
(Status-LED and main
off), then
push and
switched off again
(Status-LED and
the
Werbung
Inhaltsverzeichnis
