INNOCIGS EVIC VTWO MINI SET Bedienungsanleitung Seite 53

INNOCIGS EVIC VTWO MINI SET – OPERATING & CHANGING THE MODES
2. Installing new atomizer coils
If an atomizer coil is replaced with one which has a greater resistance than the previous one, it is
important to reset the „Base Resistance" of the atomizer. This is the resistance of the coil at room
temperature. Initiate a reset by pressing the fire button of the eVic VTwo Mini while the clearomizer
and base are not attached. After connecting the clearomizer base with a new head, „New Coil Right,
Same Coil Left" will appear on the display. Confirm that a new coil has been installed by pressing the
„up" button.
If you see this message in other instances - especially when you reinstall the same coil which is still
warm from recent use - press the "down" button, so that the „base resistance" is not reset.
Always remember to adjust the operating mode of the coil used to ensure proper temperature control.
Since atomizer coils are wearing parts, they must be changed regularly.
51