OLMLMO 4-in-1 EMF METER Benutzerhandbuch Seite 5

Use a 4-in-1 EMF Meter
1. Hold the meter as shown.
Note: Do not cover the sensor on the top of the meter with your
hand or other objects. Readings may be higher when the meter
is held than when it is lowered due to the electromagnetic field
buildup by the body. Therefore, you need to hold the bottom of
the meter to get an accurate reading when using it.
2. Button is used to toggle between measurement modes, To turn
off the meter when not in use. (The instrument will automatically
shut down after 15 minutes when not in use)
3. To measure the influence of electromagnetic fields on the
human body (or any conductive body), please use the button
(MAG), and short press W/℃/℉ to switch weighted modes. For
direct field strength measurements, use the standard mode on the
button "MAG". RF mode can be used for any radio or microwave
measurement application.
4. The bottom of the display shows the measurement value and
unit. Display peak measurement value range is displayed above
the peak icon.
5. To turn off the audio, press the audio button to turn it off. Press
the audio button again to turn on the audio.
6. Adjusting the brightness is not supported for now. It is recom-
mended to read more clearly in low light environment.
7. When the battery symbol appears on the LCD screen, it means
that the battery power is too low, and the battery must be charged.
After fully charged, the battery symbol appears after 10 hours of
continuous use, and it needs to be charged at this time.
(It takes about 1 hour to charge the 5V 1A charger from 0 to 100)
(It takes about 30 minutes to charge the 5V 2A charger from 0 to
100)
-4-