Troubleshooting; Storage - Powerplus Powew67912 Original Bedienungsanleitung

12 TROUBLESHOOTING

Incidents
Pump does not start
No flow
Pump does not switch
off
Insufficient flow
Pump switches off
after short operating
period

13 STORAGE

▪
Thoroughly clean the whole machine and its accessories.
▪
Store it out of the reach of children, in a stable and secure position, in a cool and dry
place, avoid too high and too low temperatures.
▪
Protect it from exposure to direct sunlight. Keep it in the dark, if possible.
▪ Don't keep it in plastic bags to avoid humidity build-up.
Copyright © 2024 VARO NV
POWEW67912
Causes
-No mains supply
-Floater does not switch
-Inlet sieve is clogged
-Pressure hose in bent
- Floater cannot sink down
-Inlet sieve is clogged
-Reduced pumping capacity
by dirty and abrasive water
-Thermal cutout stops pumps
due to dirty water
-Water too hot. Thermal-
cutout stops pump
P a g e
Remedies
-Check mains supply
-Bring floater in a higher
position
-Clean inlet sieve water jet
-Reset hose
- Place pump properly on shaft
ground
-Clean inlet sieve
-Clean pump and replace worn-
out parts
-Remove mains plug. Clean
pump and shaft
-Make sure that a water tem-
perature of max. 35°C is not
exceed
| 6
EN
www.varo.com