Scope Of Delivery; Installation And Setting - Meister MPH1500-1 Originalbetriebsanleitung

5452860-Bohrhammer_man 06.01.15 11:05 Seite 44
Noise/vibration information
Measured values determined in
accordance with EN EN 60745-1,
EN 60745-2-6.
The vibration emission value may
fluctuate from the specified value during
actual use of the power tool. These
fluctuations will depend on the way in
which the power tool is used.
In order to prevent the risks of
vibrations,
wear gloves when operating the tool;
limit working times and shorten the
actual operating times.
Safety measures must be taken in
order to protect the operator. As a
result, the evaluation of the influence
must be made whilst taking account
of the actual conditions of use. (All
parts of the operating cycle must be
taken into account for this purpose.
This also includes times in which the
power tool is switched off and times
in which it is switched on, but is
running without load.)
CAUTION! A certain amount of
noise is unavoidable when using
this device. Ensure you carry out
noise-intensive work during permitted
times. Maintain the quiet periods and
limit your work to the absolute
minimum.
CAUTION! The effects of noise
may cause damage to the
hearing. Only ever work with suitable
ear defenders. Anybody else in the
vicinity should thus also wear ear
defenders.
44
6 – Scope of delivery
• 1 Rotary hammer drill
• 1 Depth stop
• 1 Additional handle
• 1 Dust collector
• Transportation and storage case
• Operating instructions
• Guarantee certificate
7 – Installation and setting
Inserting a tool
CAUTION! Unplug from the
power source.
The tool holder is suitable for tools that
use the SDS-plus system.
Point the tool holder (11)
upwards. Insert a lightly oiled
tool shaft and turn to the locking
point. Push holder sleeve (12) down as
far as it will go: the tool will slide into
the accommodation shaft. Release the
holder sleeve - it must return to the
starting position.
Removing the tool
Push the holder sleeve (12) back and
remove the tool.
Setting the additional handle (8)
(Fig. 4)
Loosen the additional handle by
turning to the left, via the tool holder
to the position shown in Figure 4 and
set a comfortable side working position
by sliding about the drilling axis. Turn
the additional handle to the right to
secure.