DEFA SmartCharge 701515 Technisches Handbuch Seite 11

The charger's battery clips should be connected
to the battery terminal and stay on the battery
terminal during the battery exchange.
To use Power Supply mode, follow the steps below:
1. Turn on the vehicle cabin light or another
accessory. (The current load should be between
1A–4.0A)
2. Connect battery, 230V and turn on the charger.
3. Wait 1 minute.
4. Exchange the battery.
5. After the new battery is connected to the
vehicle, disconnect charger.
Automatic restart after power interruption
If the mains' power supply is temporarily interrupted,
the charger will continue charging when the power
supply returns. This applies to all charging steps.
Safety features
Incorrect polarity
Spark protection
Short circuit protection
Over-current protection
Over-temperature
protection
Over-voltage protection
Low voltage protection
English 11