Assembling The Device; Device Use - Royal Catering Rchw 2000 Bedienungsanleitung

Before the first use, remove all elements and clean them along with the entire device!
4.3.

Assembling the device

Assembling of water discharge and bracket for food handling tongs:
For shipping purposes the water discharge (7) and bracket for food handling tongs (8) are being
disassembled. Before first use they have to be tighten with the device, where the thread in the
water discharge additional sealed with Teflon tape.
4.4.

Device use

a) Connect the device to a power source.
b) Pour 6,5l (RCHW 2000) / 5,5l (RCHW 1000H) / 13l (RCHW 2500H) of water into the reservoir.
Make sure the water surface is not above the maximum permitted water level for the device,
marked with a MAX line.
c) Use the On/Off switch to turn the device on. The red control light will come in if there is
insufficient water in the device.
d) Insert buns and sausages into the device.
e) Twist the temperature adjustment knob clockwise to its maximum setting. The water will
begin boiling after approximately 30 minutes. Only then should you start counting down the
time required to heat up sausages and buns. Adjust the temperature according to how full
the device is and to match your requirements.
f) Use tongs to remove warm buns and sausages from the device. Pay attention to avoid burns
/ scalds.
g) Load another batch of buns / sausages into the device to be warmed up as required.
h) After use, twist the temperature adjustment knob anticlockwise as far as it will go to turn off
the heating, then use the On/Off switch to turn the device off.
i) When not in use, disconnect the device from the power source.
4.5. Use guidelines
• It may happen that by first use, the heating element produces a light smoke. This is
absolutely normal. Simply check that the smoke can evaporate and that a good aeration is
provided.
• If the water level drops below the MIN line, the device will stop heating. Monitor the water
level to ensure it is always above the minimum and so that it does not exceed the maximum.
• When in use, do not insert hands or other body parts into the device: risk of burning. After
use, wait until it cools down before touching the interior parts.
EN