Safety Instructions - Max Systems Labelmax Sp3 Kurzanleitung

inSert/replace filM caSSette | noteS
Insert/replace film cassette
Pull both release levers of the housing cover forward and
lift the housing cover upward.
Remove the «LabelMax SP3 Seal», pull out the film, and
place it on the transport roller.
Notes

Safety Instructions

• Do not disassemble the labeling system. Read this user manual before use.
• Turn off the power immediately if a malfunction occurs. Unplug the device if it or the cable starts to smoke or emit an unusu-
al smell.
• Please use original films to ensure good print quality and long device life.
Maintenance
• Cleaning exterior and label compartment: Gently wipe the labeling system exterior and the label compartment inside with a
cloth moistened with water.
• Clean the print head: Clean the print head regularly, especially if print quality decreases.
• We recommend our MaxClean cleaning wipes for safe and proper maintenance. We also offer a maintenance service, just
contact us.
QUICKSTART
1.
When handling the film cassette, pay attention to the
ridges – they must fit exactly into the designated slots in
3.
Secure the film afterwards with the media guide.
the LabelMax SP3.
EN
2.
4.
8