Cleaning And Maintenance - Cecotec Longflex 710 Pro Bedienungsanleitung

ENGLISH
Spraying too coarse. · Spray material too viscous.
· Spray material volume too
high.
· Material volume
adjustment screw turned
too far to the right (+).
· Contaminated nozzle.
· Air filter very dirty.
· Low pressure build-up in
the reservoir.
The spray jet is · Running out of material in
irregular. the container.
· Air filter very dirty.
· Nozzle gasket is missing
or worn.
The material causes · Too much spray material
"paint tears". applied.
Too much spray mist · Distance to object too
(overspray). great.
· Too much spray material
applied.
Paint on the · Dirty diaphragm.
ventilation hose. · Defective diaphragm.

5. CLEANING AND MAINTENANCE

Proper cleaning is essential for the correct operation of the paint spray gun. No warranty
claims will be accepted in case of incorrect or non-existent cleaning.
1. Unplug the power cable. Ventilate the tank in case of long breaks and after work is
finished. This can be done by briefly opening and then closing the reservoir, or by
squeezing the trigger and letting the paint flow back into the original reservoir.
2. Separate the parts of the gun. Slightly press down the hook (Fig. 3B "click"). Rotate the
front and rear of the gun against each other and separate them.
104
TOTALPAINT 750
→ Dilute the material.
→ Turn the material
volume adjustment screw
counterclockwise (-).
→ Clean nozzle.
→ Change filter.
→ Tighten the reservoir.
→ Fill the tank with material.
→ Change filter.
→ Insert an intact nozzle
gasket.
→ Turn the material
volume adjustment screw
counterclockwise (-).
→ Reduce distance.
→ Turn the material
volume adjustment screw
counterclockwise (-).
→ Clean the diaphragm.
→ Replace diaphragm.
ORIGINAL INSTRUCTIONS
3. Unscrew the container. Empty any remaining coating material back into the original
container.
4. Pour solvent or water into the container. Screw the container back on. Do not use
flammable materials for cleaning.
5. Reassemble the gun (Fig. 3).
6. Plug in the power cord, turn on the machine and spray the solvent or water into a
container or a cloth.
7. Repeat the above procedure until the solvent or water coming out of the nozzle is clean.
8. Turn off the machine and remove the plug.
9. Unscrew the container and empty it. Remove the suction tube with the gasket from the
container.
CAUTION! Never clean the seals, diaphragm, or spray gun nozzle and air holes with
metallic objects. The vent hose and diaphragm are only resistant to solvents to a certain
extent. Do not soak them in solvent, just wipe them with a cloth.
10. Clean the outside of the spray gun and the container with a cloth dampened in solvent
or water.
11. Unscrew the union nut (Fig.11, item 1) and remove the air cap (2) and nozzle (3). Clean the
air cap, nozzle with a brush and solvent or water.
WARNING! Never use the machine without the air filter; it could suck in dirt and
interfere with the machine's operation. Disconnect the spray gun from the power socket
before changing parts.
12. Replace the air filter if it is dirty (Fig. 12).
Cleaning connector
Fig. 13
To clean the cleaning connector, connect one end of the water hose to the faucet and the
other end to the cleaning connector. Open the tap to rinse the internal channel of the gun
body.
Storage
- Make sure the spray gun is clean and dry before storing it.
- Store the tool indoors and away from moisture.
- To avoid damage, wrap the power cord so that it does not twist during storage.
ORIGINAL INSTRUCTIONS
ENGLISH
105
TOTALPAINT 750