cecotec LONGFLEX 710 PRO Bedienungsanleitung Seite 52

ENGLISH
WARNING! Risk of injury. Never pull the trigger while adjusting the air cap.
Turn the air cap to the desired spray pattern position (arrow) (Fig. 5).
· Fig. 4 A = vertical flat jet → for horizontal surfaces.
· Fig. 4 B = horizontal flat jet → for vertical surfaces.
· Fig. 4 C = circular jet → for corners, edges and hard-to-reach surfaces.
Spray material volume setting adjustment
Adjust the material volume by turning the regulator located on the gun trigger guard (Fig. 6).
· -
Turn to the left → smaller volume of material
· +
Turn to the right → "greater volume of material
Spraying technique
- The spray result depends to a large extent on the uniformity and cleanliness of the
surface to be sprayed. Therefore, the surface must be carefully prepared and kept free of
dust.
- Cover all surfaces that are not to be sprayed.
- Cover screw threads or similar parts of the object to be painted.
- It is advisable to test the gun on a cardboard or similar surface to find the correct setting.
Important: Start spraying outside the target area and avoid interruptions within the target
area.
- Correct use (Fig. 7A). Be sure to keep the spray gun at a uniform distance of approx. 5 - 15
cm from the object to be painted.
- Incorrect use (Fig. 7B). Excessive accumulation of spray mist, uneven surface quality.
- Move the gun evenly from side to side or up and down, depending on the spray pattern
setting.
- Uniform gun movement results in uniform surface quality.
- If material builds up on the nozzle (A) and air cap (B) (Fig. 8), clean both parts with a
solvent or water.
Temporary interruption of work
If you need to interrupt the spraying job for a period of time not exceeding 4 hours, follow
these steps:
Unplug the device.
Important: If you have been using 2-component varnishes, clean the device immediately.
These materials dry very fast and could damage the gun if not cleaned in time.
102
TOTALPAINT 750 ORIGINAL INSTRUCTIONS
Instructions for powder blowing connector replacement
Fig. 9
To replace the connector, unscrew the union nut counterclockwise, remove the spray head,
replace the powder blow-off connector and screw the black nut clockwise again.
Powder blowing / inflation instructions
Used for cleaning narrow gaps, and can also be used for inflating, such as yoga balls, air
mattresses, children's toys, etc.
Instructions for the replacement of the cleaning connector
Fig. 10
To replace the connector, unscrew the union nut counterclockwise, remove the spray head
and nozzle, replace the cleaning connector and tighten the union nut clockwise.
4. TROUBLESHOOTING
Problem Possible cause
No material comes · Clogged nozzle.
out of the nozzle. · Clogged suction pipe.
· Material volume
adjustment turned too far
to the left (-).
· Suction tube loose.
· There is no pressure build-
up in the reservoir.
Material drips from · Loose nozzle.
the nozzle. · Worn nozzle.
· Nozzle gasket is missing
or worn.
· Set of material in the air
cap, nozzle or needle.
ORIGINAL INSTRUCTIONS
ENGLISH
Possible solution
→ Clean the nozzle.
→ Clean the suction pipe.
→ Turn right (+)
→ Insert the suction tube
correctly.
→ Tighten the reservoir
→ Tighten the nozzle.
→ Change nozzle.
→ Insert an intact nozzle
gasket.
→ Clean.
103
TOTALPAINT 750