EGO RTA2300 Bedienungsanleitung Seite 8

4. Sliding Cover Assembly
EN
5. Guard Assembly
6. Shaft
7. End cup
8. Wrench
9. Allen Key
ASSEMBLY
WARNING:
If any parts are damaged or missing, do
not operate this product until the parts are replaced. Use of
this product with damaged or missing parts could result in
serious personal injury.
WARNING:
Do not attempt to modify this product
or create accessories not recommended for use with this
machine. Any such alteration or modification is misuse and
could result in a hazardous condition leading to possible
serious personal injury.
WARNING:
To prevent accidental starting that could
cause serious personal injury, always remove the battery
pack from the machine when assembling parts.
MOUNTING THE GUARD
WARNING: Always wear gloves when mounting
or replacing the guard. Take care of the blade on the
guard and protect your hand from cutting.
WARNING: Never operate the tool without the
guard firmly in place. The guard must always be on the
tool to protect the user! When the guard is fixed, never
attempt to remove or adjust the guard, if a replacement
is needed, it should be performed by a qualified service
technician!
Loosen and remove the two screws from the guard (Fig. B),
align the guard mounting holes with the assembly holes and
then lock the guard onto the shaft base with the two screws,
together with two spring washers (Fig. C).
WARNING:
Make sure the guard is fixed according to
Fig. B & C, any reverse fixing will cause great danger!
CONNECTING THE ROTOCUT ATTACHMENT TO THE
POWER HEAD
This rotocut attachment is designed for use with EGO
Power Head PH1400E/PH1420E /PHX1600. See "
INSTALLING AN ATTACHMENT TO THE POWER HEAD"
section in the power head PH1400E/PH1420E /PHX1600
operator's manual.
8
ROTOCUT ATTACHMENT—RTA2300
OPERATION
WARNING:
Do not allow familiarity with this product
to make you careless. Remember that a careless fraction of
a second is sufficient to inflict serious injury.
WARNING:
Do not use any attachments or
accessories not recommended by the manufacturer of
this product. The use of attachments or accessories not
recommended can result in serious personal injury.
You may use this product for the purposes listed below:
Cutting:
used for cutting the grass around stakes or guard
rails, wall edges, road curbs, fences in the running traffic, or
trimming the vegetation on parking lots.
NOTICE:
When using the rotocut attachment, ensure that
no foreign objects are thrown out which entails strong risks:
broken windows, dented car bodies, slit fences, torn tree
bark or personal injury.
USING THE ROTOCUT ATTACHMENT WITH POWER
HEAD
WARNING:
To avoid serious personal injury, wear
goggles or safety glasses at all times when operating this unit.
Wear a face mask or dust mask in dusty locations.
Clear the area to be cut before each use. Remove all objects,
such as rocks, broken glass, nails, wire, or line, that can be
thrown or become entangled in the cutting attachment. Clear
the area of children, bystanders, and pets. At a minimum,
keep all children, bystanders and pets at least 15m away;
there still may be risk to bystanders from thrown objects.
Bystanders should be encouraged to wear eye protection. If
you are approached, stop the motor and cutting attachment
immediately.
Before each use, check for damage/worn parts
Check the rotocut attachment, guard and loop handle and
replace the parts that are cracked, warped, bent, or damaged
in any away.
After each use, clean the tool.
CAUTION:
Obstructions in the vents will prevent the air
from flowing into the motor housing and result in overheating
or damaged of the motor.
◾
Use only mild soap and a damp cloth to clean the tool.
Never let any liquid get inside the tool; never immerse
any part of the tool into a liquid.
◾
Keep air vents in the motor housing from debris at all
times.