EGO RTA2300 Bedienungsanleitung Seite 7

◾
Blade thrust is more likely to occur in areas where it is
difficult to see the material being cut.
◾
Do not attach any blade to a unit without proper
installation of all required parts. Failure to use the
proper parts can cause the blade to fly off and
seriously injure the operator and/or bystanders.
Discard blades that are bent, warped, cracked,
broken, or damaged in any way. Use a sharp blade
A dull blade is more likely to snag and thrust.
◾
A coasting blade/line can cause injury while it
continues to spin after the motor is stopped or
trigger is released. Maintain proper control until
the blade/line has completely stopped rotating.
◾
Battery tools do not have to be plugged into an
electrical outlet; therefore, they are always in
operating condition. Be aware of possible hazards
even when the tool is not operating. Take care when
performing maintenance or service.
◾
Do not wash with a hose; avoid getting water in
motor and electrical connections.
◾
If situations occur that are not covered in this
manual, use care and good judgment. Contact the
EGO Customer Service Center for assistance.
◾
Use only with battery packs and chargers listed in fig. A2
SAVE THESE INSTRUCTIONS!
SPECIFICATIONS
No-load Speed
Cutting Blade
Recommended Operating
Temperature
Recommended Storage
Temperature
Weight
(without battery pack)
Measured sound power level L
450±5%rpm
ABR2300
◾
0°C-40°C
◾
-20°C-70°C
NOTICE:
2.6 kg
power tool can differ from the declared value in which the
97.4 dB(A)
tool is used; In order to protect the operator, user should wear
K= 2.7 dB(A)
gloves and ear protectors in the actual conditions of use.
(PH1400E)
95.19 dB(A)
PACKING LIST (FIG. A1)
K= 1.93 dB(A)
WA
(PH1420E)
DESCRIPTION
92 dB(A)
K= 3.0 dB(A)
KNOW YOUR ROTOCUT ATTACHMENT (Fig. A1)
(PHX1600)
1. Sealing Screw
2. Gear Case
3. Blade
Sound pressure level at operator's
ear L
PA
Guaranteed sound power level L
(measured according to 2000/14/EC)
Front-assist handle
Valuation of
vibration a :
h
Rear handle
The declared vibration total value has been measured
in accordance with a standard test method and may be
used for comparing one tool with another;
The declared vibration total value may also be used in
a preliminary assessment of exposure.
The vibration emission during actual use of the
ROTOCUT ATTACHMENT—RTA2300
EN
83 dB(A)
K= 2.5 dB(A)
(PH1400E)
81.9 dB(A)
K= 3 dB(A)
(PH1420E)
85 dB(A)
K= 3 dB(A)
(PHX1600)
100 dB(A)
WA
3.3 m/s
2
K= 2 m/s
2
(PH1400E)
3.06 m/s
2
K= 1.5 m/s
2
(PH1420E)
1.52 m/s
2
K= 1.5 m/s
2
(PHX1600)
2.0 m/s
2
K= 1.5 m/s
2
(PH1400E)
2.46 m/s
2
K= 1.5 m/s
2
(PH1420E)
1.71 m/s
2
K= 1.5 m/s
2
(PHX1600)
7