Status CBL12Li Bedienungsanleitung Seite 51

OPERATION
• Place outer flange (7) on the axle of spindle.
• Tighten up M10 screw (8) using hex wrench (9).
• For safety's sake, run the appliance at maximum speed for 60 seconds after every disc
change. Be aware of unusual noises and sparks.
• Check whether all the fastening elements are correctly fitted.
• Make sure that the arrow showing the direction of rotation (if any) on the cutting or
rough grinding discs (including diamond cutting discs) and the direction of rotation of
the appliance (arrow showing the direction of rotation on the head) match.
Working procedures
NOTE: Grinding tools should only be used for the recommended applications.
Otherwise, theymcan break, be damaged or cause injuries.
Rough grinding: Never use cutting discs for rough grinding!
■ While applying moderate pressure, move the angle grinder back and
forth over the workpiece.
■ For soft material, move the rough grinding disc at a shallow angle over
the workpiece; for hard material at a slightly steeper angle.
Abrasive cutting: Never use roughing discs for cutting!
■ Use only tested fibre-reinforced cutting or grinding discs that are
approved for a circumferential speed of not less than 80 m/s.
CAUTION! The grinder continues running after being turned off. Do not try to brake it
by applying lateral counterpressure.
■ Secure the workpiece. Use clamps/a vice to hold the workpiece firmly in place. This
is much safer than simply holding it in your hand.
■ Always switch off the appliance before putting it down and wait for the appliance to
come to a complete standstill.
■ Use the appliance only for dry cutting or sanding.
■ The additional handle must be mounted on the appliance for all work.
■ Materials containing asbestos may not be processed. Asbestos is a known
carcinogen.
Always wear safety goggles!
Always wear a dust mask!
Wear hearing protection!
11
EN