Additional Safety Rules - Status Cbl12Li Bedienungsanleitung

ADDITIONAL SAFETY RULES

SERVICE
Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
Battery tool use and care
• Recharge only with the charger specified by the manufacturer. A charter that is suitable
for one type of battery pack may create a risk of fire when used with another battery
pack.
• Use power tools only with specifically designated battery packs. Use of any other
battery packs may create a risk of injury and fire.
• When battery pack is not in use, keep it away from other metal objects, lie paperclips,
coins, keys, nails, screws or other small metal objects, that can make a connection from
one terminal to another. Shorting the battery terminals together may cause burns or a
fire.
• Under abusive conditions, liquid may be ejected from the battery; avoid contact. If
contact accidentally occurs, flush with water. If liquid contacts eyes, additionally seek
medical help.
ADDITIONAL SAFETY RULES
Special safety instructions for grinding and abrasive cutting:
a) This power tool is to be used as a grinder and abrasive cutting appliance. Please follow all
safety instructions, instructions, diagrams and data that you receive with the appliance.
If you do not observe the following instructions, this can lead to an electrical shock, fire
and/or serious injuries.
b) This power tool is not suitable for sandpaper sanding, working with a steel brush or
burnishing. Using the power tool for applications for which it is not designed can lead to
hazards and injuries.
c) Do not use any accessories that have not been specifically provided or recommended
by the manufacturer for this power tool. Just because you can attach the accessories to
your power tool does not guarantee they are safe to use.
d) The maximum speed of the accessory tool used must be at least as high as the maximum
speed specified for the power tool. Accessories that rotate faster than the permissible rate
can break and throw pieces into the air.
e) The external diameter and thickness of the accessory tool used must comply with the
dimensions of the power tool. Incorrectly dimensioned accessory tools cannot be
ufficiently shielded or controlled.
f ) Attachment tools with a thread insert must match the thread of the grinding spindle
exactly. For attachment tools that are mounted using a flange, the diameter of the hole on
the attachment tool must correspond to the width of the fitment on the flange. Accessory
tools that cannot be fitted precisely to the power tool rotate unevenly, vibrate severely and
EN
6