INNOCIGS TAROT NANO Bedienungsanleitung Seite 38

INNOCIGS TAROT NANO – USING THE DEVICE
4. Automatic detection of new atomizer coils: In order to adjust the temperature
when a new atomizer head is installed, the OLED display shows "OLD LOAD:
-, NEW LOAD: +". If the atomizer head deviates from the previous one, select
the plus key and the coil resistance is automatically detected again. Select the
minus button to set the default resistance.
Setting the CCT-Mode
While on any TC mode, press the mode button three times consecutively to select
the CCT mode. Press and hold the mode button while pressing the Plus or Minus
buttons to adjust the wattage and confirm. Press the mode button again to save
your settings and exit.
Setting the Bypass-Mode
The output voltage is set and regulated in the bypass mode. The higher the charge
state of the battery, the higher is the output voltage. In this mode the device can
supply atomizer coils with a resistance in the range from 0.15 Ohm to 5 Ohm.
36