Electrical Hazard; Assembly Instruction - Vevor Rope-G-003 Benutzerhandbuch

ELECTRICAL HAZARD!

Do not use near energized power lines, as these climbers are conductive! Don't
use climbers if there are deformations of the shank, gaffs or mountings. When
climbers are NOT IN USE, always apply gaff protectors.
This product is designed for climbing wooden poles and trees and must only be
used together with a harness, lanyard and overhead life support line.
TEMPERATURE
Use this product above a minimum of-15°C (5°F) and below a maximum of +50°C
(122°F)
USER WEIGHT
This product is limited to be used by a person with maximum weight of 350 pounds
when fully equipped.

ASSEMBLY INSTRUCTION

Climbers are manufactured in accordance to the ASTM F887 standard with height
adjustment range of 13 1/5 inches (minimum) to 17 inches (maximum).
For maximum comfort, performance and safety, climber height must be adjusted
prior to initial use.
Attach lower straps to the lower strap ring so that the buckle portion of strap is
facing forward.
OPERATING INSTRUCTION
Climbers should be worn with appropriate work footwear with sufficiently strong
shanks in the sole portion of the boots.
If not installed, install lower foot straps with split ring.
Select right or left climber identified by markings on the cuff.
Step into the climber and attach lower strap securely to your footwear.
Pull the end of the strap tongue firmly through the buckle and secure.
Feed the free end of the upper Velcro strap though the cinch bar.
Pull the strap until the cuff is firmly resting against your shin.
Secure the free end around the cuff & leg, ensuring full connection of the hook to
the loop.
5