Security Systems; Overheating Protection And Tip Over Switch - Fakir Hobby Bedienungsanleitung

Overheating protection
and tip over switch
16

Security systems

The heater has a security system that in the cases
described below will automatically shutdown.
It is equipped with two overheat safety cut-out turns
off the appliance in the event of a technical fault or if
the heater is not being used properly.
If the cut-out has been activated, then turn the
function selector [B] to the "0" setting, disconnect the
heater from the mains, and remedy the fault or ensure
that the heater is being properly used.
The overheat safety cut-out is reactivated after a short
coo-ling down period, and the heater can once again
be opera-ted.
Also it is equipped with a tip over switch which swit-
ches off the heating fan with a too big inclination,
in every direction. Should this be the case, put the
device again on a horizontal surface.
The heating fan begins immediately with the preset
heating settings to heat.
ATTENTION!
Always ensure that there is adequate minimum
distances. The outflowing air must not be obstructed
by any object.
WARNING!
If you notice a defect several times, unplug the power
cord from the wall outlet and proceed in accordance
with section „Troubleshooting" in the following
chapter.
WARNING! Do not cover!
In order to avoid overheating. do not cover the heater.