Operation; Cleaning And Storage; Troubleshooting; Disposal - Livarno 1119-R Installations-, Betriebs- Und Sicherheitsinformationen

z Operation
DANGER OF OVERHEATING! Do
not operate the product while it is
still inside the packaging!
Please note: Only use the product with the
supplied mains plug. Do not connect the
product or the mains plug to any external
devices.
Please note: The product stays lit as long
as it is connected to the power supply. If you
unplug it, the product will automatically
switch off.
Timer function
To activate the timer function, keep the
„ „
button on the mains plug
7
down until the LED light turns green (see
Fig. C). The timer has now been activated.
When the timer function is switched on, the
„ „
product is switched on for 6 hours and then
switched off for 18 hours.
Replacing the LEDs
RISK OF ELECTRIC SHOCK!
Incorrect handling of the product or
incorrect installation may potentially
result in personal injury.
The light source of this product may only be
„
replaced by the manufacturer, their
designated service technician, or a similarly
qualified person.
Remove mains plug before changing bulb.
„
It is essential to ensure that all interfaces
„
are fitted with an LED.
Faulty bulbs must be immediately replaced
„
with bulbs of the same type as the one
provided or which correspond with the
manufacturer's specifications.
All technical data can be found on our
„
website: www.citygate24.de
Instructions for replacing the LEDs for
„
qualified professionals are available on our
website: www.citygate24.de
46
GB/IE/NI/CY/MT
z Cleaning and storage
cleaning the product.
For reasons of electrical safety, the product
„
must never be cleaned with abrasive
cleaning agents or immersed in water.
Use only a dry, lint-free cloth for cleaning. If
„
the product is very dirty, dampen the cloth
slightly.
When the product is not in use, store in the
„
packaging in a dry place.
z Troubleshooting
pressed
1
z Disposal
RISK OF ELECTRIC SHOCK!
Always unplug the mains power
cable from the socket before
= Fault
= Cause
= Solution
= One or more LEDs are not lighting
up.
= The LEDs are defective (e.g. due to
broken cable).
= The LEDs have reached the end of
their life cycle.
= Instructions for replacing the LEDs are
available on our website: www.
citygate24.de
= The product does not light up.
= The product is not connected to the
mains.
= Plug the mains plug
that has been properly installed (see
chapter "Connecting the power
supply").
Note the labels on the packaging
materials when sorting the waste;
they are marked with abbreviations
(a) and numbers (b) with the
into a socket
8