Assembly And Installation; Operation - Livarno 858-R Handbuch

TRIPPING HAZARD! Please make
sure that the power cable is routed
in such a way that nobody can
tread on it or trip over it�
z Assembly and installation
Please note: Take the product out of its
packaging and remove all packing material�
Check that all package contents are
„
present�
Check if the product or individual parts are
„
damaged� Should you detect damage, do
not use the product� Please contact the
retailer via the service address indicated�
Insert the LED module
„ „
star via the designated fixture as shown
1
in Fig� D�
Fold the lower side upwards and close the
„ „
star� Attach the LED module
and right sides using the gland nut
Fig� D)�
Hang the product in a location of your
„ „
choosing�
FIRE HAZARD!
Never hang the product above an
open fire or heat source. This may
damage the product and excessive heat
build-up can cause a fire.
RISK OF DAMAGE! Take sufficient
measures to secure the product from
falling down�
Use the hook provided to hang the
„ „
5
product from a suitable ceiling (see Fig� A)�
Connect power supply
RISK OF ELECTRIC SHOCK!
Plug the connector
„ „
the mains plug
3
Tighten the union cap
„ „
thread of the connection socket
30
GB
into the open LED
6
on the left
6
(see
2
into the socket
8 9
(see Fig� B)�
on the screw
7
�
9
Plug the mains plug
„ „
has been correctly installed�
Please note: When using outdoors, plug
the mains plug
ensure splash protection�
z Operation
DANGER OF OVERHEATING! Do
not operate the product while it is
still inside the packaging!
Please note: Only use the product with the
supplied mains plug� Do not connect the
product or the mains plug to any external
devices�
Please note: The product stays lit as long as
it is connected to the power supply� If you
unplug it, the product will automatically
switch off�
Timer function
To activate the timer function, keep the
„ „
button on the mains plug
10
down until the LED light turns green (see
Fig� C)� The timer has now been activated�
When the timer function is switched on, the
„ „
product is switched on for 6 hours and then
switched off for 18 hours�
Replacing the LEDs
RISK OF ELECTRIC SHOCK!
Incorrect handling of the product or
incorrect installation may potentially
result in personal injury�
The light source of this product may only be
„
replaced by the manufacturer, their
designated service technician, or a similarly
qualified person.
Instructions for replacing the LEDs for
„
qualified professionals are available on our
of website: www�citygate24�de
All technical data can be found on our
„
website: www�citygate24�de
into a socket that
3
in to an IPX4 socket to
3
pressed
3