Assembly And Installation - Livarno 1119-R Installations-, Betriebs- Und Sicherheitsinformationen

before plugging it into the mains. Never
use the product if it has any signs of
damage.
Protect the mains from sharp edges,
„
mechanical stress and hot surfaces.
Never touch the mains adapter if your
„
hands are wet.
Never touch the uninsulated part of the
„
mains plug when plugging it in or out!
Never carry the product by the mains
„
power cable.
Fully unwind the cable before using it.
„
You should only connect the product to an
„
easily accessible power outlet socket so that
you can quickly disconnect it from the
power supply in the event of a fault.
Always unplug the mains plug before
„
assembling, dismantling or cleaning the
product.
Always plug out the product if it is not
„
going to be used for an extended period,
e.g. holiday, or if you want to set it up in a
different place.
Before using the product, make sure that the
„
mains voltage matches the supply voltage
required by the product (see "Technical
data").
If the product has any identifiable faults,
„
stop using it immediately.
RISK OF INJURY!
Incorrect handling of the product
may potentially result in personal
injury.
The light source may only be replaced by
„
the manufacturer, service technician or a
similarly qualified person.
Never look directly into the light source.
„
Do not connect the product to a power
„
source while still inside the packaging.
There is a risk of overheating!
WARNING! DO NOT USE THE LIGHT
„
CHAIN UNLESS ALL SEALING RINGS
HAVE BEEN PROPERLY MOUNTED.
The operating unit is intended exclusively
„
for use with LED modules.
The control gear of this product may only
„
be replaced by the manufacturer, its
designated service technician, or a similarly
qualified person.
TRIPPING HAZARD! Please
„
make sure that the power cable
is routed in such a way that
2
nobody can tread on it or trip over it.
z Assembly and installation
Please note: Take the product out of its
packaging and remove all packing material.
Check that all package contents are
„
present.
Check if the product or individual parts are
„
damaged. Should you detect damage, do
not use the product. Please contact the
retailer via the service address indicated.
FIRE HAZARD!
Never hang the product above an
open fire or heat source. This may
damage the product and excessive heat
build-up can cause a fire.
RISK OF DAMAGE!
Take sufficient measures to secure
the product from falling down.
Connect power supply
RISK OF ELECTRIC SHOCK!
Plug the connector
socket of the mains plug
6
Fig. B).
Tighten the union cap
„ „
thread of the connection socket
Plug the mains plug
„ „
has been correctly installed.
Please note: When using outdoors, plug
the mains plug in to an IPX4 socket to
1
ensure splash protection.
into the
5
(see
1
on the screw
4
�
6
into a socket that
1
GB/IE/NI/CY/MT
45