Buttons/Display/Remote Control - EUROM AC7000 Bedienungsanleitung

BUTTONS / DISPLAY / REMOTE CONTROL
GENERAL
 Your airco is fitted with control buttons, a display and a remote control. Both of these options allow
you to enter almost the same instructions. The 'change ºC-°F' and 'timer' instructions can only be
entered with the remote control
 Before using the remote control for the first time you must remove the protective foil from the
battery. The remote control must be powered with a CR2035 3V battery. Press small button A in the
indicated direction to open the battery compartment. You can now pull the battery compartment out
of the remote control (B) and change the battery. Now close the compartment in the original
manner.
 Point the remote control at the airco during use. The remote
control has a range of 7 metres.
 Take the battery out of the remote control when you are not
using it for a long period of time in order to prevent leakage.
 The device will not work when you press two buttons
simultaneously.
LIGHTS AND BUTTONS
The lights on the display (I) show
which mode is active.
1 = automatic operation
2 = cooling
3 = de-humidification
4 = ventilate
5 = Degrees Celsius
6 = Degrees Fahrenheit
7 = Timer
8 = ventilation mode
Use the buttons on the display (I) and remote control (II) to operate the device:
A = On/off: this switches the airco on and off.
B = Mode: this selects the mode: auto, cooling, de-humidification or ventilation. The mode switches
every time you press the button. When you use the remote control, press the desired mode.
C = Ventilation strength: use this to select gentle or strong ventilation.
D & E = Higher/lower: use this to set the desired temperature. You also use this to adjust the timer.
~ 30 ~