Basic Instructions - Addi Addinet Handbuch

1. Basic instructions

1.1.
Determine the loom width (and thus the lace width) by inserting the
needles into the holes on both bars. To do this, hold the needles on the
lower end - at the addi hearts - so that you can easily slip into the bar and slip
out later.
1.3.
Push the crochet needle
through the loop and stitch 1
single crochet (sc). After the sc, hold
the crochet needle point down and
give the loom another half turn.
16
1.2.
Create a loop with the thread
around the right needle and
knot it in the middle between the
first and second loom.
If you are creating a cuff with just
two needles, then the knot should
lie in the middle between the two
needles.
Hold the thread in the left hand and
give the loom a half turn from right
to left.
1.4.
Continue with sc by inserting
the crochet needle under the
front stitch section in every left loop.